Worked example
Example: 30 g/L at 8 mmol/(g h), 50 m3. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Biomass concentration (dry cell weight) | 30.000 g/L |
| Specific oxygen uptake (mmol O₂ per g dry cells per hour) | 8.0000 - |
| Broth volume | 50.000 m³ |
| Saturation dissolved oxygen | 7.2000 mg/L |
| Dissolved oxygen to hold (above critical) | 1.5000 mg/L |
| Oxygen absorbed from the air | 20.000 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| Oxygen uptake rate | 7.6795 kg/(m³·h) |
| Oxygen demand of the broth | 383.98 kg/h |
| kLa needed | 1,347.3 1/h |
| Air flow at 0 °C, 1 atm | 6,419.3 Nm³/h |
| Air flow per broth volume per minute (air at 0 °C, 1 atm) | 2.1398 |
Open this example in the calculator and change any input.
Formula
\(OUR = q_{O_2}X, \quad k_La_{req} = \frac{OUR}{C^* - C_{crit}}, \quad Q_{air} = \frac{OUR\cdot V}{0.2095\,\eta_{O_2}}\cdot22.414\ \mathrm{L/mol}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(X\) | Biomass concentration (dry cell weight) | kg/m³ |
| \(q_{O_2}\) | Specific oxygen uptake (mmol O₂ per g dry cells per hour) | - |
| \(V\) | Broth volume | m³ |
| \(C^*\) | Saturation dissolved oxygen | kg/m³ |
| \(C_{crit}\) | Dissolved oxygen to hold (above critical) | kg/m³ |
| \(\eta_{O_2}\) | Oxygen absorbed from the air | - |
| \(OUR\) | Oxygen uptake rate | kg/(m³·s) |
| \(\dot m_{O_2}\) | Oxygen demand of the broth | kg/s |
| \(k_La_{req}\) | kLa needed | 1/s |
| \(Q_{air}\) | Air flow at 0 °C, 1 atm | Nm³/s |
| \(vvm\) | Air flow per broth volume per minute (air at 0 °C, 1 atm) | - |
Method and standards
Oxygen balance.
Where it is used
- Fermenter blower and sparger sizing.
- Yeast propagation aeration.
Common mistakes
- Mixing mmol and mg units.
- Assuming full oxygen absorption.
Assumptions and limits
- Steady state; ideal gas at 0 °C, 1 atm.
- vvm is on normal air (0 °C, 1 atm); vvm quoted at inlet or actual conditions is larger by the temperature and pressure ratio.
- X is dry cell weight and q_O₂ is per gram of dry cells; q_O₂ is entered as a plain number in mmol/(g·h).
References
- Doran
- Bioprocess Engineering Principles
- 2nd ed. (Academic Press, 2013)
- ch. 10 (oxygen demand and transfer)
Questions and answers
What is vvm?
Volume of air per volume of broth per minute; 0.5–1.5 is common in aerobic fermenters.
Why keep DO above a critical value?
Below it the cells' oxygen uptake falls and growth or product formation slows; for yeast and most bacteria it is about 5–10 % of air saturation.
What do the defaults give?
30 g/L at 8 mmol/(g·h): OUR 7.7 kg/(m³·h) (240 mmol/(L·h)), kLa needed about 1,350 /h: higher than air alone usually gives.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.