Worked example
Example: 1.5 t car at 90 km/h, 2 % grade. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Vehicle mass | 1,500.0 kg |
| Rolling resistance coefficient | 0.012000 - |
| Drag coefficient | 0.32000 - |
| Frontal area | 2.2000 m² |
| Speed | 90.000 km/h |
| Road gradient (rise/run) | 2.0000 % |
| Air density | 1.2000 kg/m³ |
| Drivetrain efficiency | 90.000 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| Rolling resistance | 176.48 N |
| Aerodynamic drag | 264.00 N |
| Gradient resistance | 294.14 N |
| Total road load | 734.63 N |
| Power at the wheels | 18.366 kW |
| Power from the engine or motor | 20.406 kW |
Open this example in the calculator and change any input.
Formula
\(F = mgC_{rr}\cos\theta + \frac12\rho C_dAv^2 + mg\sin\theta, \quad P_e = \frac{Fv}{\eta_d}\ (Fv \ge 0), \quad P_e = Fv\,\eta_d\ (Fv < 0)\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(m\) | Vehicle mass | kg |
| \(C_{rr}\) | Rolling resistance coefficient | - |
| \(C_d\) | Drag coefficient | - |
| \(A\) | Frontal area | m² |
| \(v\) | Speed | m/s |
| \(G\) | Road gradient (rise/run) | - |
| \(\theta\) | Road angle, arctan G | rad |
| \(g\) | Standard gravity, 9.806 65 | m/s² |
| \(\rho\) | Air density | kg/m³ |
| \(\eta_d\) | Drivetrain efficiency | - |
| \(F_r\) | Rolling resistance | N |
| \(F_a\) | Aerodynamic drag | N |
| \(F_g\) | Gradient resistance | N |
| \(F\) | Total road load | N |
| \(P_w\) | Power at the wheels | W |
| \(P_e\) | Power from the engine or motor | W |
Method and standards
Road-load equation.
Where it is used
- Vehicle and fleet energy estimates.
- Tractor and truck sizing for plant haulage.
Common mistakes
- Using gradient in degrees as per cent.
- Ignoring headwind.
Assumptions and limits
- Steady speed; still air.
- Downhill with a negative total load, P_e is the wheel power reduced by the drivetrain efficiency: the power that reaches the engine or motor, not the power it must supply.
References
- Road-load equation (Gillespie, Fundamentals of Vehicle Dynamics (SAE, 1992), ch. 4)
Questions and answers
Why does fuel use rise so fast at high speed?
Drag power rises with speed cubed: 20 % more speed needs about 70 % more drag power.
What is a typical rolling coefficient?
About 0.008–0.012 for car tyres on asphalt, 0.005–0.008 for truck tyres, 0.02–0.05 on gravel.
What do the defaults represent?
A 1.5 t car at 90 km/h up a 2 % grade.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.