FireCADCalc

Tank Wetted Area at a Liquid Level

Wetted surface area of a vertical or horizontal cylindrical tank at a liquid level, with ends or bottom, for heat loss, fire exposure or coating estimates.

Thermal power plantProcess steam and utilitiesSugar mill and cogenerationChemical and fertiliserPulp and paperFood, dairy and textile

Inputs

Examples: Horizontal 3 m × 10 m, 2 m levelVertical 6 m × 8 m, 5 m level

Results

Flat ends and bottom assumed; dished heads add a little area. For fire relief, the applicable code defines which wetted area counts (often up to a height above grade).

Wetted area122.52m²
Total surface area207.35m²
Wetted share59.091%
Liquid volume141.37m³

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Horizontal 3 m × 10 m, 2 m level. The inputs, in the units selected above:

InputValue
Tank orientationHorizontal (flat ends)
Diameter3.0000 m
Length (horizontal) or height (vertical)10.000 m
Liquid level2.0000 m

Applying the formula below gives:

ResultValue
Wetted area67.331 m²
Total surface area108.38 m²
Wetted share62.122 %
Liquid volume50.060 m³

Open this example in the calculator and change any input.

Formula

\(\theta = 2\arccos\frac{r - h}{r}, \quad A_w = r\theta L + 2\cdot\frac{r^2}{2}(\theta - \sin\theta)\ \text{(horizontal)}, \quad A_w = \pi r^2 + \pi Dh\ \text{(vertical)}\)

Variables

Symbol Meaning SI unit
\(\text{orientation}\) Tank orientation -
\(D\) Diameter m
\(L\) Length (horizontal) or height (vertical) m
\(h\) Liquid level m
\(A_w\) Wetted area m²
\(A_t\) Total surface area m²
\(A_w/A_t\) Wetted share -
\(V\) Liquid volume m³

Method and standards

Segment geometry.

Where it is used

  • Tank heating and insulation.
  • Fire exposure and coating quantities.

Common mistakes

  • Using total area for heat input.
  • Ignoring dished heads on long horizontal tanks.

Assumptions and limits

  • A level above the tank height (vertical) or diameter (horizontal) is taken as full and flagged.

  • The result is the geometric wetted area. Fire-relief codes count only the wetted area up to a set height above grade (and treat heads in their own way); apply that limit yourself.

  • Flat ends.

References

  • Circular segment geometry (definitions)

Questions and answers

Why wetted area?

Heat flows into a tank mainly through the liquid-wetted wall; it sets heat loss, heating and fire-exposure loads.

How is a horizontal tank's wetted shell found?

From the central angle θ of the liquid surface: wetted shell = rθL.

What do the defaults represent?

A horizontal tank 3 m diameter, 10 m long, 2 m of liquid.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.