Worked example
Example: 3 m × 8 m, 8 mm shell, 10 mm 2:1 heads. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Inside diameter | 3.0000 m |
| Shell length (tangent to tangent) | 8.0000 m |
| Shell thickness | 8.0000 mm |
| Head thickness | 10.000 mm |
| Head type | 2:1 ellipsoidal |
| Steel density | 7,850.0 kg/m³ |
| Allowance for nozzles, supports and welds | 10.000 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| Shell mass | 4,747.6 kg |
| Mass of two heads | 1,541.9 kg |
| Total with allowance | 6,918.5 kg |
| Internal volume | 63.617 m³ |
Open this example in the calculator and change any input.
Formula
\(m_s = \pi(D + t_s)Lt_s\rho, \quad m_h = 2k_A(D + t_h)^2t_h\rho, \quad V = \frac{\pi D^2}{4}L + 2k_VD^3\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(D\) | Inside diameter | m |
| \(L\) | Shell length (tangent to tangent) | m |
| \(t_s\) | Shell thickness | m |
| \(t_h\) | Head thickness | m |
| \(\text{heads}\) | Head type | - |
| \(\rho\) | Steel density | kg/m³ |
| \(f_a\) | Allowance for nozzles, supports and welds | - |
| \(m_s\) | Shell mass | kg |
| \(m_h\) | Mass of two heads | kg |
| \(m\) | Total with allowance | kg |
| \(V\) | Internal volume | m³ |
Method and standards
Geometry.
Where it is used
- Cost and transport estimates.
- Foundation and lifting loads.
Common mistakes
- Forgetting the heads.
- Using nominal plate thickness with large corrosion allowance as weight.
Assumptions and limits
Head factors are for the standard shapes: 2:1 ellipsoidal, hemispherical and ASME flanged-and-dished torispherical (crown radius equal to D, knuckle radius 6 % of D). Other torispherical heads (10 % knuckle, Klöpper, Korbbogen) differ by several per cent.
Head plate area is taken on the diameter D + t_h (near the mean surface); the head volume uses the inside diameter D. A flat head is a disc of diameter D + t_h: a plate that overhangs the shell, and straight flanges, add mass.
Thin-walled approximation.
References
- Shell and head geometry (definitions; standard head area and volume factors)
Questions and answers
Why add an allowance?
Nozzles, reinforcing pads, supports, internals and weld metal typically add 10–20 % to bare shell and heads.
Which diameter for mass?
The mean diameter of the shell plate; for estimates the difference is small.
What do the defaults represent?
A 3 m × 8 m vessel with 8 mm shell and 10 mm 2:1 ellipsoidal heads.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.