Worked example
Example: LPG sphere 10 m, level 6 m, 550 kg/m³. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Inside diameter of the sphere | 10.000 m |
| Liquid level from the bottom | 6.0000 m |
| Liquid density | 550.00 kg/m³ |
Applying the formula below gives:
| Result | Value |
|---|---|
| Liquid volume | 339.29 m³ |
| Total volume of the sphere | 523.60 m³ |
| Share filled | 64.800 % |
| Liquid mass | 186.61 t |
Open this example in the calculator and change any input.
Formula
\(V = \frac{\pi h^2 (3R - h)}{3}\)
\(V_{tot} = \frac{\pi D^3}{6}\)
\(V / V_{tot}, \quad m = V \rho\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(D\) | inside diameter | m |
| \(R\) | radius | m |
| \(h\) | liquid level | m |
| \(\rho\) | liquid density | kg/m³ |
| \(V\) | liquid volume | m³ |
| \(V_{tot}\) | total volume | m³ |
| \(V / V_{tot}\) | share filled | - |
| \(m\) | liquid mass | kg |
Method and standards
The liquid occupies a spherical cap of height h; its volume is π h² (3R − h)/3.
Where it is used
- Gauging LPG, ammonia and water spheres.
- Building a level–volume table.
- Checking inventory.
Common mistakes
- Using outside instead of inside diameter.
- Ignoring nozzles and internals.
- Using density at a different temperature.
Assumptions and limits
- Perfect sphere; internals not deducted.
References
- Spherical cap volume
Questions and answers
How much does a 10 m sphere hold at a 6 m level?
339 m³, 64.8 % of its 524 m³; at 550 kg/m³ LPG that is 187 t.
Why is the level not proportional to volume?
The sphere is narrow at the top and bottom and widest at the middle, so the volume per metre of level changes.
What fill limit applies to LPG spheres?
Set by the vessel code and the liquid's expansion; this calculator gives the volume at a level, not the safe filling limit.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.