Worked example
Example: 925 °C for 4 h, 1 mm wanted. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Carburising temperature | 925.00 °C |
| Time at temperature | 4.0000 h |
| Case depth wanted | 1.0000 mm |
Applying the formula below gives:
| Result | Value |
|---|---|
| Total case depth after the time | 1.2558 mm |
| Carburising factor (depth after 1 h) | 0.62788 mm |
| Time for the wanted depth | 2.5365 h |
Open this example in the calculator and change any input.
Formula
\(d = \frac{31.6 \sqrt{t}}{10^{6700/T}} \ \ (\text{in, h, °R}) \;=\; \frac{803 \sqrt{t}}{10^{3722/T}} \ \ (\text{mm, h, K})\)
\(t_t = \left(\frac{d_t}{k}\right)^2\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(T\) | Carburising temperature | K |
| \(t\) | Time at temperature | s |
| \(d_t\) | Case depth wanted | m |
| \(d\) | Total case depth after the time | m |
| \(k\) | Carburising factor (depth after 1 h) | m |
| \(t_t\) | Time for the wanted depth | s |
Method and standards
Harris's diffusion relation: case depth grows with the square root of time, with a temperature factor of Arrhenius form.
Where it is used
- Planning carburising cycles for gears and shafts.
- Checking a supplier's quoted case depth.
- Comparing temperatures for productivity.
Common mistakes
- Confusing total and effective case depth.
- Using furnace set point instead of part temperature.
- Ignoring the low carbon potential at the start of a cycle.
Assumptions and limits
- Saturated carbon potential at the surface; plain carbon and low-alloy steels.
References
- F.E. Harris (1943)
- Metal Progress 44
- total case depth
Questions and answers
What case does 4 h at 925 °C give?
About 1.26 mm total case: the carburising factor is 0.63 mm per √h at that temperature.
How long for 1 mm?
About 2.5 hours at 925 °C: depth goes with the square root of time, so doubling the depth takes four times as long.
Is this effective case depth?
No, total case; effective case (to about 50 HRC) is smaller, often about two-thirds.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.