Worked example
Example: 1.5 t car, 0.8 g braking, 0.6 g cornering. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Vehicle mass | 1,500.0 kg |
| Static front axle weight share | 58.000 % |
| Centre-of-gravity height | 0.55000 m |
| Wheelbase | 2.6500 m |
| Track width | 1.5500 m |
| Braking deceleration (in g) | 0.80000 - |
| Lateral acceleration (in g) | 0.60000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Longitudinal load transfer | 2.4424 kN |
| Front axle load while braking | 10.974 kN |
| Rear axle load while braking | 3.7358 kN |
| Lateral load transfer (whole vehicle) | 3.1318 kN |
| Rollover threshold t/2h (in g) | 1.4091 |
Open this example in the calculator and change any input.
Formula
\(\Delta W_x = W a_x\frac hL, \quad \Delta W_y = Wa_y\frac ht, \quad a_{y,roll} = \frac{t}{2h}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(m\) | Vehicle mass | kg |
| \(f_f\) | Static front axle weight share | - |
| \(h\) | Centre-of-gravity height | m |
| \(L\) | Wheelbase | m |
| \(t\) | Track width | m |
| \(a_x\) | Braking deceleration (in g) | - |
| \(a_y\) | Lateral acceleration (in g) | - |
| \(\Delta W_x\) | Longitudinal load transfer | N |
| \(W_f\) | Front axle load while braking | N |
| \(W_r\) | Rear axle load while braking | N |
| \(\Delta W_y\) | Lateral load transfer (whole vehicle) | N |
| \(a_{y,roll}\) | Rollover threshold t/2h (in g) | - |
Method and standards
Moment balance.
Where it is used
- Brake balance and tyre loads.
- Loading of plant trucks and tractors.
Common mistakes
- Ignoring raised CG with loads.
- Using track for longitudinal transfer.
Assumptions and limits
The page warns when an axle load comes out negative (wheel lift-off) or when the lateral acceleration exceeds t/2h (lateral transfer above half the weight); beyond those points the results have no physical meaning.
Rigid body; steady acceleration.
References
- Load transfer ΔW = ma h/L and ΔW = ma_y h/t (Gillespie, Fundamentals of Vehicle Dynamics (SAE, 1992), ch. 3 and 9)
Questions and answers
Why are front brakes larger?
Braking moves load onto the front axle, so the front tyres can generate most of the stopping force.
What is the static stability factor?
t/2h: the lateral acceleration at which a rigid vehicle would tip; SUVs and loaded trucks have low values.
What do the defaults represent?
A 1.5 t car braking at 0.8 g and cornering at 0.6 g.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.